Bosch Washing Machine Dispenser Drawer Removal and Cleaning

BoschBosch Washing MachineModerate⏱ 5 - 10 minutes

Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».

The dispenser drawer, also called the detergent drawer, holds washing powder, detergent, and fabric conditioner before they enter the wash. Over time, residue can build up into residue, grime, and mold. Remove the drawer to give it a thorough clean and wipe the dispenser cavity. This guide was written for the Bosch Serie 4 VarioPerfect washing machine and also applies to Siemens washing machines with a similar release-button drawer design.

🧰 Tools

Brush
Shop Towels or Rags

ШагиSteps

Prepare the washer

Turn off the washing machine, unplug it, and make sure no wash cycle is running.
Keep water and damp cloths away from the controls, plug, and wall outlet.
Clean the detergent drawer at least once a year, or whenever residue, mold, or conditioner buildup appears.
This procedure was written for the Bosch Serie 4 VarioPerfect washing machine.
Use the same method on a Siemens washing machine only if the drawer has the same release-button design.

Remove the dispenser drawer

Find the dispenser drawer on the left side of the front panel.
Pull the drawer straight out until it stops.
Press the release button down firmly to lower the retaining clip.
Keep the button pressed and pull the drawer completely out of the machine.

Clean the drawer shell

Rinse the drawer under hot water.
Use an brush to scrub away grime, dirt, mold, and washing powder residue.
Use only a spare cleaning brush, and don't reuse it for personal care.
Older drawers can look much dirtier than a new washer drawer, especially where detergent and conditioner collect.

Clean the removable inserts

Lift out the measuring level if the drawer has one fitted.
Lift out the catch in the middle of the drawer.
Rinse the removable pieces and the drawer under a hot tap.
Use the brush to scrub the exposed areas where dirt and mold collect.
Reinstall the measuring level and the middle catch after they are clean.

Clean the dispenser cavity

Wipe inside the dispenser cavity with a non-scratch damp cloth while the drawer is removed.
Don't use a brush inside the cavity, as it can fall into the detergent and conditioner opening and get trapped.
Clean only the reachable surfaces, and don't force the cloth down into the opening.

Refit the dispenser drawer

Line up the dispenser drawer with its runners.
Push the drawer in slowly until the release clip reaches the front edge.
Don't slam the drawer into place, as this can damage the clip.
Press the release button down again so the clip tucks underneath.
Push the drawer home until it closes fully.
Dry any visible water around the dispenser and plug the machine back in when the area is dry.

The dispenser drawer should slide smoothly and sit flush when fully installed. Repair didn't go as planned? Ask our Answers community for help.

«Bosch Washing Machine Dispenser Drawer Removal and Cleaning» — автор eCuration, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →