How to Use Diagnostic Mode on a GE Top-Load Washer

GEGE Washing MachineModerate⏱ 5 - 15 minutes

Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».

Use the built-in diagnostic mode to read stored fault codes, run component tests, and reset control logic on your GE top-load washer. This guide covers models with either a ring of status lights or an 8-segment display so you can confirm common problems before ordering parts or calling for service.

ШагиSteps

Power cycle the washer

Unplug the washer for about 30 seconds to clear the control.
Plug the cord back in and wait 15–30 seconds for the control to boot.
Confirm the unit is a GE top load model with circular status lights or an 8-segment display; this procedure does not apply to front-load models.

Initiate diagnostic mode

Press and hold the Start button on the control panel.
While holding Start, rotate the cycle selector knob seven clicks counter-clockwise.
Release the Start button; a chime confirms that diagnostics is active.

Understand navigation within diagnostics

Turn the knob clockwise to advance to the next test number.
Turn the knob counter-clockwise to go back to the previous test number.
Test 1 is Fault Code Mode and is shown by the Spin light or the digit 1 on the display.

Display stored fault codes

With Fault Code Mode highlighted, press Start once to show the first stored code.
Press Start again to cycle to the next stored code.
If all status lights flash together, no additional codes are stored.
Press Start after the flash sequence to return to the first code if needed.

Interpret the fault code output

On circular-light models, count the lit position; for example, the third light corresponds to fault code 4.
On 8-segment display models, read the numeric code directly from the display.
Write each code down and compare it with the 32-code chart supplied by GE.
Specific repair instructions for each code are not included in the source material; consult official documentation for corrective actions.

Return to diagnostic menu or repeat code review

Rotate the knob once in either direction to exit Fault Code Mode and return to the main diagnostic menu.
Press Start without turning the knob to replay the stored codes from the beginning.

Run component tests

Turn the knob to choose any of the 18 available control or component tests.
Press Start to launch the highlighted test; turn the knob again to end it and select another test.
The washer automatically locks the lid during spin and agitation tests; keep hands clear.
A failed lid lock will prevent spin or agitation tests from operating.

Exit diagnostic mode

Press and hold the Start button for 3–5 seconds until all diagnostic lights turn off.
The control returns to normal cycle selection once the lights extinguish.

Record any stored codes before leaving diagnostics so you can reference the proper repair path afterward. Repair didn't go as planned? Ask our Answers community for help.

«How to Use Diagnostic Mode on a GE Top-Load Washer» — автор Ben Schlichter, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →