Whirlpool #WTW5000DW Drive Belt Replacement

WhirlpoolWhirlpool Washing MachineEasy⏱ 25 minutes

Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».

This guide provides step-by-step instructions for replacing the Whirlpool WTW5000DW top-load washing machine drive belt. Usually, the main reason the washing machine fails to spin properly is due to worn or broken bearings, seals, or drive belt. The guide is simple yet can still cause water or electrical damage if not followed appropriately, especially if the washer is located inside the house with other electrical appliances. It's important to work in a clean and dry space for a safe working environment. Before you begin, disconnect the washer from the power outlet.

🧰 Tools

Drive Belt
5/16" Nut Driver
Vacuum Cleaner
Safety Gloves for Electrical Work
Shop Brush

ШагиSteps

Step 1

Before performing any repairs or replacements, please be aware of your surroundings and ensure you have plenty of safe space to work.
Cut the washing machine's water and power before beginning.
There will be two valves: one for hot water and one for cold water. Don't forget to unplug the electricity as well.

Step 2

Follow the water line to your washer.

Step 3

Unplug both water lines.
Mark which one is for hot water and which is for cold water.

Step 4

Safely lower the washing machine; it may contain small amounts of water. Just in case, have a towel ready.
Then, with your nut-driver remove the metal backing of the washing machine.

Step 5

Go to the back of the washing machine; you will find the main panel for the drive belt, which is located behind a clear plastic lid.

Step 6

Use the 5/16" Nut Driver to unplug both of the 5/16" hex bolt screw on both sides of the lid and then take the lid out.

Step 7

After removing the lid, you will find the drive belt of the washing machine.
Pull the belt out slowly; it's designed to fit tightly, so this may be difficult.

Step 8

Use a brush or towel to clean the wheel where the belt was.

Step 9

Put the new drive belt on, make sure the smooth side faces away from the wheel, and the side with many lines faces toward the wheel.
It's essential because the belt needs grip to spin the washer.

Step 10

Reinstall the lid and screw in the two 5/16" hex bolts back in.

Step 11

Make sure everything is back to the original stage before lifting the washing machine back on. The back and lid should be the only two components you altered here.

Step 12

Plug the water line back in and the electricity—hot water for the hot water line, and the same for cold water before turning it back on.

Step 13

Congratulations, you have finished replacing the washing machine drive belt!

To reassemble your appliance, simply follow these instructions in reverse.

«Whirlpool #WTW5000DW Drive Belt Replacement» — автор Khanh Le, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →