Whirlpool WED5100VQ1 Dryer Door Switch Replacement

WhirlpoolWhirlpool DryerEasy⏱ 30 minutes - 1 hour

Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».

If your Whirlpool dryer (model WED5100VQ1) won't start or continues to operate while the door is open, use this guide to replace the dryer door switch. Wear and tear from normal use can cause the dryer door switch to fail. When this occurs, the dryer switch will not transmit signals for the dryer to recognize when its door is open, causing it to malfunction. Before using this guide to repair a dryer that won't start, troubleshoot for other common causes, such as a faulty power source, plug, or cord. Only use this guide if you can confirm the dryer door switch is the cause of the dryer malfunction.

🧰 Tools

Phillips #0 Screwdriver
Metal Spudger

ШагиSteps

Step 1

Unplug the dryer's power cord.

Step 2

Open and remove the lint screen.

Step 3

Remove the screws next to the lint screen opening.

Step 4

From the front of the dryer, insert a prying tool in the seam where the locking tabs are located (about 2 inches away from a corner).
Be sure the prying tool sits above the two legs of the locking tab.
Press the tool to release the locking tab.
Lift the top of the dryer.
Caution: Forcing the top of the dryer to lift without fully releasing the locking tab could result in pinching, crushing, or shearing of your fingers and hands.
Repeat the step on the opposite corner to fully release the top of the dryer.

Step 5

Lift the top of the dryer 90 degrees to lock it in place.
If necessary, pull out the dryer until there's enough space for the top of the dryer to open 90 degrees.

Step 6

Open the dryer door.

Step 7

Remove the screws next to the door switch.
The drier door switch should be located at the upper right corner of the door frame.

Step 8

From the top of the dryer, pinch and push down on the mounting tabs holding the dryer door switch to unplug them.

Step 9

Pull out and disconnect the door switch.
If necessary, insert a prying tool into the door switch’s push-in connector to disconnect.

Step 10

Grab and align the new door switch’s connector with the wire harness.
Insert the new door switch's connector into the wire harness until snug.

Step 11

Place the door switch to its original location.
Ensure the door switch’s screw sockets align with the dryer's screw holes.

Step 12

From the front, hold the door switch in place
Continue to hold the door switch in place until the screws are in place and fully tightened.
Hand-tighten the screws to secure the door switch.
Finish tightening the screws using a screwdriver.

Step 13

On the top side of the dryer, plug the switch’s mounting tab back in place.

Step 14

Close the dryer door.

Step 15

Close the top of the dryer.
Press down the top of the dryer to lock it in place.

Step 16

On the lint screen opening, put the two screws back in place.

Step 17

Close and/or return the lint screen.

Step 18

Plug the dryer's power cord back in.
If you pulled the dryer out earlier, push it back to the original location first.
Adjust the dryer vent as needed to avoid crushing it while pushing back the dryer to its original location.

«Whirlpool WED5100VQ1 Dryer Door Switch Replacement» — автор David, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →