LG WM3050CW Electrical Noise Filter Replacement

LGLG WM3050CWModerate⏱ 10 - 20 minutes

Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».

Use this guide to replace the electrical noise filter in your LG WM3050CW Washing Machine. This filter protects the washer's circuit boards from power surges and spikes. If your washer doesn't power on, this can be a common culprit.

Сначала выполнить:Do these first:

How to Remove the Top Panel in Your LG WM3050CW Washing Machine

🧰 Tools

Phillips #2 Screwdriver

ШагиSteps

Step 1

Before you begin your repair, perform the following:
Turn off the main water supply
Unplug your washer
Disconnect all water connections at the rear of your washer

Unfasten the top panel

Use a Phillips driver to remove the two bottom 16.5 mm-long screws securing the top panel brackets.

Remove the top panel

Slide the top panel 1-2 inches towards the rear of the device to disconnect its clips.

Step 4

Tilt the top panel upward to completely disconnect it from the chassis.
Remove the top panel.

Disconnect the noise filter

Disconnect the two spade connectors attached to the noise filter.
Always grip cables by their connectors and not the wires themselves.

Unfasten the noise filter

Use a Phillips driver to remove the 12.5 mm-long screw securing the noise filter.

Remove the noise filter

Slide the noise filter towards the front of the device to unclip it from the chassis.
Pull the filter downward to completely separate it from the device.
Remove the filter.

To reassemble your device, follow these instructions in reverse order. Take your e-waste to an R2 or e-Stewards certified recycler. Repair didn’t go as planned? Ask our Answers community for help.

«LG WM3050CW Electrical Noise Filter Replacement» — автор Bill Gilbert, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →