LG WM3050CW Detergent Bellows Replacement

LGLG WM3050CWModerate⏱ 45 minutes - 1 hour

Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».

Use this guide to replace the detergent bellows or detergent hose in your LG WM3050CW Washing Machine. The detergent bellows connects the detergent dispenser assembly to the tub.

Сначала выполнить:Do these first:

How to Remove the Top Panel in Your LG WM3050CW Washing Machine

🧰 Tools

Phillips #2 Screwdriver
Slip Joint Pliers
Masking Tape
Magnetic Mat Replacement Pen

⚙️ Parts

4738ER2002A - LG Washer Bellow

ШагиSteps

Step 1

Before you begin your repair, perform the following:
Turn off the main water supply
Unplug your washer
Disconnect all water connections at the rear of your washer

Unfasten the top panel

Use a Phillips driver to remove the two bottom 16.5 mm-long screws securing the top panel brackets.

Remove the top panel

Slide the top panel 1-2 inches towards the rear of the device to disconnect its clips.

Step 4

Tilt the top panel upward to completely disconnect it from the chassis.
Remove the top panel.

Disconnect the control panel

Disconnect the three harness connectors for the control panel.
Always grip cables by their connectors and not the wires themselves.

Unclip the control panel cable

Use your hands to unclip the control panel cable from the detergent dispenser.

Unclip the control panel cable

Insert a flathead screwdriver between the chassis and the plastic clip securing the control panel cable.
Compress the clip and slide it out of the chassis to remove it.
Move the cables out of the way of the detergent dispenser hoses before you continue.

Detergent dispenser hose information

To prevent confusion, label each hose and its corresponding dispenser connection.
You can use masking tape or mark the components themselves.

Step 9

Use slip joint pliers to pinch the detergent dispenser hose clamp and pull it away from the assembly.

Step 10

Use slip joint pliers to gently rotate the detergent dispenser hose back and forth around its connection and loosen it.

Step 11

Pull the detergent dispenser hose straight off its connection on the assembly.
Repeat the loosening and removal procedure for each hose.

Disconnect the dispenser

Use a Phillips driver to loosen the screw securing the bellows to the detergent dispenser.
Pull the bellows straight off its connection on the dispenser to disconnect it.

Disconnect the bellows

Use a Phillips driver to loosen the screw securing the bellows to the drum.
Pull the bellows straight up from the drum to disconnect it.

Remove the bellows

Remove the bellows.

To reassemble your device, follow these instructions in reverse order. Take your e-waste to an R2 or e-Stewards certified recycler. Repair didn’t go as planned? Ask our Answers community for help.

«LG WM3050CW Detergent Bellows Replacement» — автор Bill Gilbert, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →