LG WM3050CW Vent Valve Plunger Replacement

LGLG WM3050CWModerate⏱ 30 - 45 minutes

Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».

Use this guide to replace the vent valve plunger in your LG WM3050CW Washing Machine. The vent valve plunger vents moist air out the back of the washer. The plunger may stick open, which would allow excess liquid to slosh out and drip down the back of the washer.

Сначала выполнить:Do these first:

🧰 Tools

Phillips #2 Screwdriver
Slip Joint Pliers
Masking Tape
Magnetic Mat Replacement Pen
Flathead 4 mm Screwdriver

ШагиSteps

Step 1

Before you begin your repair, perform the following:
Turn off the main water supply
Unplug your washer
Disconnect all water connections at the rear of your washer

Unfasten the top panel

Use a Phillips driver to remove the two bottom 16.5 mm-long screws securing the top panel brackets.

Remove the top panel

Slide the top panel 1-2 inches towards the rear of the device to disconnect its clips.

Step 4

Tilt the top panel upward to completely disconnect it from the chassis.
Remove the top panel.

Inlet valve information

To prevent confusion, label each valve and its corresponding hose.
You can use masking tape or mark the components themselves.
Repeat the labelling procedure for each valve and its corresponding connector.

Disconnect the inlet valve

Disconnect the three spade connectors from the inlet valve.
Always grip cables by their connectors and not the wires themselves.

Step 7

Place a dry rag under the inlet valve to soak up any lingering water.

Step 8

Use slip joint pliers to pinch the inlet valve hose clamp and pull it away from the inlet valve assembly.

Step 9

Use slip joint pliers to rotate the inlet valve hose back and forth around its connection and loosen it.

Step 10

Pull the inlet valve hose straight off its connection on the inlet valve assembly.

Step 11

Repeat the previous three steps for each remaining hose attached to the inlet valve assembly.

Remove the filters

If your replacement part comes with filters pre-installed, skip this step.
Use needle nose pliers to pull the inlet valve filters straight out of the inlets in the chassis.
Remove the filters.

Unfasten the inlet valve assembly

Use a Phillips driver to remove the two 14.4 mm‑long screws securing the inlet valve assembly.

Remove the inlet valve assembly

Pull the inlet valve assembly straight out of its slot in the chassis to remove it.

Reposition the vent hose

Use a Phillips drive to loosen the screw securing the vent hose.
Lift the vent hose straight off the drum to expose the vent valve plunger.

Remove the vent valve plunger

Use two flathead screwdrivers, or similar tools, to pry the vent valve plunger up enough to grip it with your fingers.
Pull the plunger straight up to remove it.

To reassemble your device, follow these instructions in reverse order. Take your e-waste to an R2 or e-Stewards certified recycler. Repair didn’t go as planned? Ask our Answers community for help.

«LG WM3050CW Vent Valve Plunger Replacement» — автор Bill Gilbert, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →