LG WM3050CW Pressure Sensor Replacement
LGLG WM3050CWModerate⏱ 15 - 30 minutes
Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».
Use this guide to replace the pressure sensor in your LG WM3050CW Washing Machine.
The pressure sensor detects how much water is in the tub. The sensor LG uses in these washers have no moving parts, so it's unlikely to break. If the sensor malfunctions, the tub may under-fill or overfill.
🧰 Tools
- Phillips #2 Screwdriver
ШагиSteps
1
Step 1
- Turn off the main water supply
- Unplug your washer
- Disconnect all water connections at the rear of your washer
2
Unfasten the top panel
- Use a Phillips driver to remove the two bottom 16.5 mm-long screws securing the top panel brackets.
3
Remove the top panel
- Slide the top panel 1-2 inches towards the rear of the device to disconnect its clips.
4
Step 4
- Tilt the top panel upward to completely disconnect it from the chassis.
- Remove the top panel.
5
Disconnect the pressure sensor
- Disconnect the spade connector from the pressure sensor.
6
Step 6
- Disconnect the hose from the pressure sensor.
7
Unfasten the pressure sensor
- Use a Phillips driver to remove the 16.5 mm-long screw securing the pressure sensor.
8
Remove the pressure sensor
- Rotate the pressure sensor toward the left edge of the washing machine to unclip it from the main board cover.
9
Step 9
- Lift the pressure sensor away from its slot on the main board cover to remove it.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Ask our Answers community for help.
«LG WM3050CW Pressure Sensor Replacement» — автор Bill Gilbert, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →