Kenmore 80 Series Washing Machine Lid Switch Replacement
KenmoreKenmore 80 Series Washing MachineEasy⏱ 25 minutes
Инструкция на английском (оригинал iFixit). Непонятные термины — в разделе «Основы → Словарь».
Electric clothing-washing machines have sensor switches about doors. A switch is a moving mechanical part. In Kenmore 80, this switch can wear-out, or its plastic screw bosses can break. Workspace: have room in front of your washing machine, enough space such that it could tip over forward so its front is on floor, in front of its present position.
🧰 Tools
- cruciform turnscrew
- prise bar
- 5/16 inch wrench
⚙️ Parts
- Switch
ШагиSteps
1
open console
- Control panel console is fastened with two screws. Remove screws, pull bottom end of control panel forward (towards you), swing it upward, rest it in flipped position.
2
unplug switch
- Press on tab to release clip/latch. Grip connector, not wires, and pull it off of fixed connector.
3
open case
- Use prise tool to remove two case clips. Pull top of case towards you, rock case (almost whole cabinet: case top, front, left & right) on its bottom front edge as axis, lower front of case until it rests on floor.
4
remove wiring
- Case grounding wire is fastened on with one screw, 5/16 (five sixteenths) inch hexagon head. Unhook wires from the guide hooks.
5
remove switch
- Switch is fastened on with two screws.
- Remove connector from case top, squeezing connector's panel mount tabs to free it. when replacing: Face connector with its wedge bump facing frontward.
To reassemble your device, follow these instructions in reverse order.
«Kenmore 80 Series Washing Machine Lid Switch Replacement» — автор unsubstantiated, iFixit, лицензия CC BY-NC-SA 3.0. Показано без изменений. Открыть оригинал и комментарии →